Omni Installation Notices

• Install filter on cold water only. Do not use on water lines exceeding 100 degrees F (38 degrees C). Water pressure minimum is 25 psi and the maximum is 125 psi.
  
  

• Protect unit from direct sunlight and freezing temperatures. Keep above 35 degrees F.
  
  

• Avoid exposure of filter housing to torch.
  
  

• Do not use pipe dope or similar compounds. They can ruin plastic. Use Teflon tape to seal pipe thread joints.
  
  

• Keep unit clean with soap and water. Do not use spray cleaners or insecticides near unit.
  
  

• Intended for indoor, non-commercial use only.
  
  

• For extended periods of non-use turn the water off and remove the filter cartridge. Place the cartridge in a plastic bag, seal, and refrigerate.
  
  

• Safety glasses must be worn during installation.
  
  

• Tubing and hose dimensions are based on outside diameters (OD).
  For water line sizes other than those listed, consult a plumber or hardware store.
  
  

• Before using the water, flush the new filter for 30 minutes.
  
  

• Run drinking or cooking water for 5 - 7 seconds prior to collecting the water for use.
  
  

• Change cartridge stated at manufacturer's suggested interval or sooner is you notice a change in color, taste or low water pressure.
  
  

• Filter is not a water purifier and is not intended for use with contaminated water.
  
  

• Comply with all state and local laws regarding the installation of water treatment devices.
  
  

• Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
  
  

• The rubber O-ring provides the water tight seal between the cap and the housing. It is important that the O-ring be properly seated in the groove in the housing or a water leak could occur.
  
  

• The contaminants or other substances removed or reduced by this water filter device are not necessarily in your water.
  
  

• Use of ANY cartridge other than an Omni filter will void your warranty.
  
  

• Replace tank O-ring with every second filter cartridge change.
  
  

• DO NOT use wrench to tighten tank.
  
  

• Use wrench ONLY for tank removal.

Call 1-406-889-5288 for questions

Call our order line: 1-406-889-5288 or send an e-mail: info@omni-water-filters.com

www.omni-water-filters.com